Bilge Fitting Pro
Machined aluminum bilge fittings are a clean replacement of the bulky plastic fittings usually supplied with aftermarket bilge pump kits. These fittings have a 3/4" inch hose barb flange machined on them so no hose clamp is necessary. Available in Clear, Black, Green, Red, Blue, Orange and Purple anodized colors.
- Hose Barb Diameter (OD): 3/4" Inch
- Thread Length: 1/2" Inch
- Nut Width: 1-1/4" Inch
- NOTE: Install with 1" Inch Hole Saw Bit.
MotoMarine Sea-Doo Exhaust Race Plate
The CNC machined T6 billet aluminum spacer installs seamlessly between exhaust manifold and cylinder head. This is a standalone Exhaust Race Plate but also designed specifically as part of our Rotax Catalyst Delete Kit, with DUAL Bosch O2 Sensor ports, as well as includes threaded ports for easy installation for EGT sensor in each exhaust port, eliminating the need for modifications to cast aluminum OEM exhaust manifold. Block-off fittings are supplied for use when sensors are not installed. Anodized to prevent corrosion and includes stainless steel hardware. Key Features: DUAL Bosch O2 Sensor Ports Integrated EGT Sensor Ports Increases Engine RPM & Top Speed CNC machined from T6 Billet Aluminum Plug-n-Play Design Requires No Modifications to OEM Exhaust Manifold Designed for Supercharged 1503 & 1630 engines.
NMEA Engine Gateway for BRP Engines
Gateway for Volvo Penta, BRP Rotax, SmartCraft (Mercury, Mercruiser) and J1939 engines to NMEA 2000 marine electronics networks. It will provides you with engine revolutions, motor hours, coolant temperature, battery voltage, warning and alarms, fuel rate and other data on the screen of your chart plotter.
Rotax Catalyst Delete Kit
This kit allows you to delete the Catalyst from any vessel with a Rotax engine. With this kit, you can eliminate the catalyst and relocate the O2 Sensors. This kit is pretty much Plug and Play. **NO MODIFICATION TO ECU OR WIRING HARNESS** There are only 2 things that you will need to "figure out" depending on the configuration on your boat are the cooling lines and exhaust hoses. PLEASE NOTE, THAT YOU NEED ONE KIT PER ENGINE. with a Twin Engine Boat, you need to order 2 kits. This system works on any Rotax powered Scarab, Chaparral Vortex, Seadoo Switch, Williams Tender, ABJet Tender... etc
